Tail Wheel Question

[RanRan]

If one opts for the bigger 3200 tail wheel after buying a plane is it much of hassle to swap the tail wheel assembly out? Does fabric need to cut?

[Pete D]

Not at all. Very simple, one bolt installation for either. No fabric needs to be cut, and the leaf springs are interchangeable.

Going from the stock tail wheel to the 3200 type you need the tail wheel, a different length bolt, a bushing that goes in the tail wheel and an adapter that goes between the leaf spring and the tail wheel. The steering springs are the same for either, but the number of links in the steering chains may change.

Pete D.

[RanRan]

OK. Thanks Pete.

[Kenny Edwards]

Hi all fellow builders
can somebody direct me to where I can find a parts breakdown and instructions for the 3200 one hole tail wheel,SP83102-002...just a little different to the standard fit in the finish manual...as I'm just about to fit the assembly to my kit
Thanks
Kenny Edwards
Aussie Carbon Cub
Brisbane
Australa

[clipwingcub]

http://www.airframesalaska.com/v/vsp...stallation.pdf



Sent from my iPad using Tapatalk

[terry]

Hi all fellow builders
can somebody direct me to where I can find a parts breakdown and instructions for the 3200 one hole tail wheel,SP83102-002...just a little different to the standard fit in the finish manual...as I'm just about to fit the assembly to my kit
Thanks
Kenny Edwards
Aussie Carbon Cub
Brisbane
Australa

Did you get the photos I sent you kenny

[Kenny Edwards]

Did you get the photos I sent you kenny

Thanks Terry ,I certainly did,just a bit confused as the manual just didn't address the situation properly....
take it easy
Ken

[N867SP]

Check Dropbox under "Misc Docs". "Optional Tailwheel"


Pete
CCK-1865-0078
️N9PW
Severna Park, MD
Sent from my iPad using Tapatalk