The EX3 Executive Glass Touch manual revision B has now been uploaded to the EX3 kit Dropbox

This update addresses 12 Kit Manual Update forms

Release notes:

-Revisions page: Listed pages that have changed
-Page 28 Replaced figure G3X30 with version from previous revision of the manual to fix incorrect depiction of the pitot tube mast installation. Also corrects p/n call out in section G-G.
-Page 30 Replaced old p/n VP9050-001 with current p/n HDW-261-741 (and added HDW-261-741 to current panel kit BOM) upper right view.
-Page 33 Corrected hardware call out in section D-D for trim potentiometer mounting
-Page 47 added pinout for magnetometer harness back in that was removed on a previous revision
-Added new page 59-61 with Roll Servo information
-Added new Page 63 with Manifold Pressure Sensor installation fittings and note re tygon tubing is now black not yellow.
-Page 64 Added a new page 64 with OAT probe installation information
-Page 65 Added a caution to not power up COM/XPDR equipment without a properly grounded antenna connected.
-Page 68 73: Added notes regarding CAN bus terminator plugs.
-Page 77 82 Added note re cap/stow unused wire numbers for GTR 200 COM installation