CKKM208 - EX2 Finish Kit Manual Rev NC Released

[Pete D]

Updated Revision has been added to the DropBox. This update addresses some missing information and other minor updates & corrections.





Purpose:

Update Manual

Revision:

1. Revised Flap Cone Installation instructions (Section 10) to include 10in-lbs torque and safetying bolts after flap install.

2. Updated figure (FN8) to show exploded view of flap cone installation with more detail (p. 41)

3. edited left hand interior panel photo (photo 123) to show correct hardware qty. (p. 64)

4. revised LH interior installation figure (FN16) to include note for placement of front edge of panel outside of fuselage tube (p. 65)

5. revised RH interior installation figure (FN17) to include note for placement of front edge of panel outside of fuselage tube (p. 68)

6. updated seat installation figure (FN20) to call for SC15000-015 instead of SC1500-043 (p. 78)

7. replaced photo 176 with Figure FN24 to show correct orientation of stabilizer link (p. 89)

8. updated VG sticker figure (FN 43) to show outboardmost VG location (p.149).

9. added Section 49 for Extended Range Tank Lid Prep (p. 157)

10. added Section 82 for Tank Lid Installation (p. 299)

11. added Section 88 for Cowl Flaps (p. 314)

[ceslaw]

Pete: Thanks for alerting us to the update.

[PBY Catalina]

Thanks Pete !

[ceslaw]

Building a third Carbon Cub with the new wing manual and the 'old' wing manual side by side. I am finding a lot of seemingly little revisions that will produce a better result. For example, trimming the lower portion of the tail on the aft ribs that don't fasten to a center rib presumably so they will flex a bit and look blend better under the fabric.