I am about to seal the plenum and baffles. I would like to hear how to get a clean professional looking job. My RTV experience is always a mess. I'll use black RTV silicone gasket/seal maker.

The EX(1) Firewall Froward Manual says to mark all places where the plenum will contact the engine and all mating surfaces. That implies I would lay a bead down all around that line and those surfaces then seat the plenum.

  • Suggestions to keep it neat as possible?
  • How big of a bead do I put down?
  • How do I clean up a mess?
  • Is this better done with extra hands?


Screen Shot 2022-03-08 at 9.38.01 PM.png