Page 1 of 3 123 LastLast
Results 1 to 10 of 25

Thread: Long High angle climbs

  1. #1
    Senior Member TroyBranch's Avatar
    Join Date
    May 2015
    Location
    Calgary Alberta Canada
    Posts
    313

    Default Long High angle climbs

    Have any of you tried continuous high angle climbs, like 70mph indicated for long periods of time less than half fuel solo?

    My usual routine would be climb hard and I found that after a minute or so in the climb the engine would not be quite as smooth so I just pulled the throttle a touch. That always fixed it. I figured it was just the modified carb set up on the 340 that was causing that. Pulling mixture did not help and just rose EGTs to a level that I would not except.

    Yesterday I figured I would leave the throttle in and see what happened. Full rich and continuous climb I would start to see a slight decay in fuel flow from high 12's to low 12's and roughness would start. (Flying above 5000ft) Drop the noes a touch, it would stop, pull the throttle a touch it would stop. Level flight it would flow over 13gph and smooth the whole time.

    Two people on board, full throttle smooth the entire time in the climb as I just cant get those really high climb angles.

    I think it is a combination of two things, the carb does not like the high angle attitude as the float is not doing a proper job and with lower fuel in the wing, it cannot provide enough head pressure for the fuel demand. I did a flow test before first flight but I know I could never set the plane up as high as angle it can do solo. Who new it could climb so steep

    Have anyone else tried this? Just wondering if I should be hunting for an underlying issue.

    Thanks

  2. #2
    Senior Member
    Join Date
    Mar 2016
    Location
    Idaho
    Posts
    386

    Default Re: Long High angle climbs

    How long is a 'long period of time' in your climb. I climb hard at times but I wouldn't guess for more than a minute or two.

    I usually fly frequently and can try to duplicate your observations.

    What carb do you have on your plane?
    Dan Arnold
    KEUL

  3. #3
    Senior Member TroyBranch's Avatar
    Join Date
    May 2015
    Location
    Calgary Alberta Canada
    Posts
    313

    Default Re: Long High angle climbs

    I would say a minute or two as well. With my 1/4 tanks on the last flight when I tested it only took about 60 sec to start getting less smooth climbing at 70. Once passing through 6000ft from a 3500ft take off it got rough, pull the throttle a touch and dropped the nose a touch and smooth again. I plan to review the logs when I get time. I just filled it up and I will try the same thing with full fuel, I don't recall an issue with full fuel as I could not climb at such a steep angle.

    The engine was shipped in 2016. The engines before had a carb that would just not run smooth at full throttle I thought. I think they made changes to the design to solve that. I was told that before I started building so my memory has no detail of it.

  4. #4
    Senior Member
    Join Date
    Mar 2016
    Location
    Idaho
    Posts
    386

    Default Re: Long High angle climbs

    I believe you are correct in regards to the carb issues on earlier models.

    I recieved my motor in late 2018 and it has the Avstar -4PA carb. Which tanks do you have; extended or standard?

    I'll probably fly tomorrow but I have half fuel on board.
    Last edited by aeroaddict; 05-26-2020 at 08:30 AM.
    Dan Arnold
    KEUL

  5. #5
    Senior Member
    Join Date
    Jul 2015
    Location
    Broken Arrow, OK
    Posts
    841

    Default Re: Long High angle climbs

    Troy,

    Check out this Mike Busch article. I remembered reading it years ago where he talks about partially shutting the throttle. Specifically, it’s on page 3 (ironically on the same page as a Cubcrafters ad! Haha)

    https://resources.savvyaviation.com/...ugh-engine.pdf

    Quote Originally Posted by TroyBranch View Post
    I would say a minute or two as well. With my 1/4 tanks on the last flight when I tested it only took about 60 sec to start getting less smooth climbing at 70. Once passing through 6000ft from a 3500ft take off it got rough, pull the throttle a touch and dropped the nose a touch and smooth again. I plan to review the logs when I get time. I just filled it up and I will try the same thing with full fuel, I don't recall an issue with full fuel as I could not climb at such a steep angle.

    The engine was shipped in 2016. The engines before had a carb that would just not run smooth at full throttle I thought. I think they made changes to the design to solve that. I was told that before I started building so my memory has no detail of it.
    Dave Embry
    "You only live once.......but if you do it right.........once is enough."..

  6. #6
    Senior Member
    Join Date
    Mar 2016
    Location
    Idaho
    Posts
    386

    Default Re: Long High angle climbs

    Interesting, thanks. Next time I fly, I'll climb the plane like a home sick angel and see what happens.
    Dan Arnold
    KEUL

  7. #7
    Senior Member
    Join Date
    Mar 2016
    Location
    Idaho
    Posts
    386

    Default Re: Long High angle climbs

    Flew this morning.

    OAT 60F, 1/3 fuel, DA 2300, climbed 68mph, full rich at WOT for 2 mins. No issues, no loss or degradation in power. EGT/CHT all within limits.
    Dan Arnold
    KEUL

  8. #8
    Senior Member TroyBranch's Avatar
    Join Date
    May 2015
    Location
    Calgary Alberta Canada
    Posts
    313

    Default Re: Long High angle climbs

    Thanks for doing that. I guess I now need to figure out what is going on....

    I will try at full fuel and see if it makes a difference.

    Do you remember your fuel flow?

    Quote Originally Posted by aeroaddict View Post
    Flew this morning.

    OAT 60F, 1/3 fuel, DA 2300, climbed 68mph, full rich at WOT for 2 mins. No issues, no loss or degradation in power. EGT/CHT all within limits.

  9. #9
    Senior Member
    Join Date
    Mar 2016
    Location
    Idaho
    Posts
    386

    Default Re: Long High angle climbs

    Fuel flow? I'm pretty sure the fuel was flowing. That turn thingy below the accelerator knob said 'both'

    While I have the Skyview HDX system, I kept the plane light and simple and do not have the red cube.
    Dan Arnold
    KEUL

  10. #10
    Senior Member TroyBranch's Avatar
    Join Date
    May 2015
    Location
    Calgary Alberta Canada
    Posts
    313

    Default Re: Long High angle climbs

    Are you saying I should just remove the red cube to solve my issue.

    In all seriousness that could be something.....just need someone with the red cube to do the same test.

    I really think there is a flow restriction issue, why else would flow gradually drop and engine start to not run smooth.

    I need to do this full fuel test.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •