I've chosen the EarthX ETX680C battery for my CarbonCub EX. There is a lot of good discussion here about battery choices... pro and con...so I hope this 'battery' thread does not go off the rails in that direction. I've made my choice.
I would like to ask how EarthX users integrated the EarthX BMS warning into the G3X. The EarthX Battery Management System (BMS) has a fault indicator light on the case. A black wire spade connector out of the top of the battery case can be used to wire a single warning light on the panel. I have also heard that warnings can be integrated and displayed on G3X where parameters/warnings can be set appropriate for the Lithium LiFePO3 battery.
Can someone give details on how that is done? Do I wire it to the GEA 24 engine interface module? What connector, what pin, single wire + a ground somewhere? How do I configure it on screen on G3X configuration page?
Screen Shot 2021-03-04 at 12.48.38 PM.png