Seat Beat Floor Bolts Installation

[karaka29211]

Concerning the seat belt floor installation as referenced EX-2 Fuselage Manual Page 75. What bolts or screws are required to be installed on outer most side on both sides of the aft floor join. Photos on Page 75 seem outdated particularly #137 as gussets are different and seem to suggest the belts are attached more towards the centreline. Finish manual Page 47 FN9 provides no clarity. Can anyone please provide photos of correct installation of seat belt floor fitting, or clarify the instructions?

[Jon Delamarter]

I think the bit that's perhaps throwing you off is that there are multiple gussets in that area. One is for the aft seat belt and the others are float fittings.

Here, I have marked up FN9 from page 47 of the Finish Manual; the float fittings are red and the seatbelt attach point is in green.

PLEASE NOTE: The floorboard has been removed for clarity. Also, the washers in the manual are improperly annotated as AN916-416; they should be AN960-416 as in the pic here. The floorboard will be between the washer and the fuselage gusset marked green.

If you have more questions or need any further assistance, please drop an email to kitsupport@cubcrafters.com or call the new Kit Support HelpDesk line from 9-12 or 2-3:30 Pacific time.

Kind regards,

Aft Seat Belt Attach.png