Lighting Wiring and Installation

[jmorrical]

I am ready to cover the fuselage. Can't decide what I'm to do with this orange tail light harness ring wire connector. I know the Molex and spade connectors are to connect to the installed rudder wiring for the tail light. It looks like it's a solder shield splice for the ground of the shield. Where do I connect it?

KWTn7D5HTSqp38VIkuw+Rg.jpg

[Daveembry]

Jim,

Don’t worry about it for now. Later the ring connector end will be a ground connected to the little bolt/nut that holds the Data plate onto the fuse mounting plate there under the right stabilizer.

I am ready to cover the fuselage. Can't decide what I'm to do with this orange tail light harness ring wire connector. I know the Molex and spade connectors are to connect to the installed rudder wiring for the tail light. It looks like it's a solder shield splice for the ground of the shield. Where do I connect it?

KWTn7D5HTSqp38VIkuw+Rg.jpg

[Pete D]

Now would be a good time to clean the powder coat off by the screw hole it goes on the back side of the data tag tab so you don't have to do it inside the tail withe the fabric on.