I just talked to an engraver. He said stainless engraving is pretty rare and specialized. (he couldn't do it) Does anyone know of a place that can match the engraving on my data plate to add my name? Will CC do it if I send it to Mitch?
Jake
I just talked to an engraver. He said stainless engraving is pretty rare and specialized. (he couldn't do it) Does anyone know of a place that can match the engraving on my data plate to add my name? Will CC do it if I send it to Mitch?
Jake
Jake
Finished CCEX N96FV!
I had a machinist do mine. He is a buddy of mine so he didn't charge. It did take a while to do by the time we made a mount and programmed the computer.
Looks good.
Sent from my SM-G920V using Tapatalk
Jake
Finished CCEX N96FV!
The Trophy guy I went to said his machine wouldn't do a good job. Stainless is too hard. I found a place in town that does stainless. I guess that machine is like a tiny router and will engrave the stainless much deeper than a traditional engraving machine.
Sent from my iPad using Tapatalk
Jake
Finished CCEX N96FV!
Jake:
Attached is how mine came out. Lettering not as bold as the CC ID info, but frankly I prefer it that way. If you want deep engraving to match the CC lettering I can see where that may be an issue.
I am sure the engraving shop you found will do a nice job. Post a picture when done.
Chuck
IMG_7440.jpg
Good idea on the year. Wish I would have done that!
He is how it turned out.
Sent from my SM-G920V using Tapatalk
Jake
Finished CCEX N96FV!