FIREWALL: Populating Adel Clamps

[gderamel]

I've looked in the FUSELAGE, FINISH, ENGINE ??? Manuals... but can't find a figure showing which ADEL CLAMPS and hardware to populate the firewall. FS48 (pg 145 Fuselage) covers the grommets, but nothing on the AN hardware or Adels. Any suggestions on where to look?

Also, the edge of the vinyl, which has the insulation sandwiched between it and the Titanium firewall... doesn't adhere nicely. Any thoughts or suggestions on how to make a nice finished edge? Granted the interior panels cover most of the edges (except for the top) but it'd be nice to keep it all clean. I'll try to post a picture tomorrow of the as-build condition.

[N867SP]

It is also on Dropbox under "Misc"


Pete
CCK-1865-0078
️N9PW
Severna Park, MD
Sent from my iPad using Tapatalk

[N867SP]

FYI- there are 51 files under "miscellaneous information" folder on Dropbox, a majority of which are not in any of the manuals. Good idea to review these, especially prior to boot cowl install and firewall forward.


Pete
CCK-1865-0078
️N9PW
Severna Park, MD
Sent from my iPad using Tapatalk

[gderamel]

It is also on Dropbox under "Misc"

THANKS! I forgot about the "MISCELLANEOUS INFORMATION" DropBox files. The further I get along in the build, ironically, there are fewer parts, but more files and instructions scattered in various locations - not nicely located in one folder.

[N867SP]

Read my shirt...




Pete
CCK-1865-0078
️N9PW
Severna Park, MD

Sent from my iPhone 7 using Tapatalk