Thread: Chuck and Ryan's Build Tips

  1. #341
    Senior Member
    Join Date
    Mar 2016
    Location
    Idaho
    Posts
    393

    Default Re: Chuck and Ryan's Build Tips

    Epic car then and now!
    Dan Arnold
    KEUL

  2. #342
    Senior Member ceslaw's Avatar
    Join Date
    Sep 2013
    Location
    Carterville, IL
    Posts
    593

    Default Re: Chuck and Ryan's Build Tips

    Review

    Now that the Cub is flying it may be worthwhile to see if the various modifications and upgrades documented in this thread were worth the trouble.

    IMG_2928.jpg

    1. Rear seat. Constructing a frame for a Cubcrafters rear seat was a big project, but worth it. The passenger sits about three inches higher and more upright than with the sling seat. Looking to the side of the pilot, one can see out the front of the windscreen. One’s head is just a couple of inches below the fabric headliner panel.

    IMG_2973.jpg

    2. Belly camera. This was added to provide a good view of potential landing areas, but as it turns out, the best use to date is assuring the plane is perfectly aligned on the parking “T”. Other pilots will be impressed, if they don’t know about the camera.

    ParkingImage.jpg

    3. Glare shield fans. The fans were added to assure air movement from behind the instrument panel to keep the windscreen clear and draw heat away from the electronics. The fans work well providing a gentle flow of air and their position causes no glare on the windscreen whatsoever.

    IMG_2176 (2).jpg

    4. Acme Aero struts. What can I say? Having flown several years with the ASOS we have a good basis for comparison. The ‘bounce’ on landing is improved. This is a HUGE improvement and should be the standard system on the Carbon Cub.

    5. Relocating the ELT. One benefit of moving the ELT to the extended baggage compartment is the addition of space below the seat for one’s wallet, phone, or other items that are hard to conveniently store in an accessible location while flying. It also makes the ELT more accessible and the antenna feed line shorter. As noted in the prior discussions, it improved the ability of the ELT to receive a GPS signal which means the plane can be located in literally minutes rather than hours.

  3. #343
    Junior Member
    Join Date
    Jul 2024
    Location
    Omaha, NE
    Posts
    1

    Default Re: Chuck and Ryan's Build Tips

    Quote Originally Posted by Andy View Post
    Three people with similar misalignment problems for the stab drive system. Did anyone tell CubCrafters about this and, if so, what was the answer?
    Good question. I'm having the same issue on my 2014 SS.

  4. #344
    Senior Member ceslaw's Avatar
    Join Date
    Sep 2013
    Location
    Carterville, IL
    Posts
    593

    Default Re: Chuck and Ryan's Build Tips

    Quote Originally Posted by AspenKOMA View Post
    Good question. I'm having the same issue on my 2014 SS.
    https://forum.cubcrafters.com/showth...ll=1#post27469

    You may be the fourth documented case.

    Just a guess, but I wonder if CC considers the motor assembly as capable of so much torque that a bit of tension in the set up isn't an issue? Indeed the motor was able to overcome the 'stiffness' in three planes I built, but a bit of fine tuning helped the 'stiffest' of the three.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •