Activity Stream

The IBBS, as installed in CubCrafters aircraft, does not enable power output unless it senses that the charging input voltage is less than about 11.5...

I have searched the Forum to find the best thread to "Reply To". When I switch the IBBS - On it does not power the G3X. G3X will powers up when...

It used to have an annunciation during the ignition test. For some reason it stopped. I updated to 9.51 yesterday (I know, it’s been out awhile) but...

I looked at my Sound configuration settings this morning. I could find no setting that would enable any aural alert for ignition switching. I...

I’ll definitely check it out and keep it bookmarked for future reference. Appreciate the effort in creating and sharing such resources!

Kind of noce to get the tone on the test. Guessing it will also give when there is a failure along with CAS. BTW, was et to Stereo only. I'll...

One thing to check…….be sure the arm that holds the alternator isn’t powdered coated. Some genius powder coated some of them and they are the ground...

I don’t know if it helps or not but here are a couple of posts I made about this type event. ...

The GDU 465 has two sound paths to the GTR 200. One is stereo and usually used for music from the XM receiver, the other is mono and usually used...

Could you possibly have a bad starter battery?

I’ll check that out. Odd the the Music button in the GTR has to be pressed to get annunciations. But, don’t get the ignition test annunciations any...

I have a vague recollection that this problem is related the a GTR 200 squelch level settings. I don't think I can help more without checking my own...

Guess I spoke a bit too soon. The intermittent loss of battery charging and decreasing voltage returned again today. It remained for the entirety of...

Left Lewiston after delivery first week of August with all the annunciators working. Some time in the past they quit working unless the music button...

The pods come clear gel coat / CF, but can be scuffed and painted.

Thanks for the update. Good to know the solution to a problem.

Update on Sky-tec Starter Issue. After replacing the solenoid on my Sky-tec starter a few months ago , I've had no intermittent "failure to...

You'll need a different rear accessory case for an engine driven fuel pump. Considered full injection when building my EX-2 but decided against it. ...

may have solved issue, the positive lead on the earth x wasnt fully secured, I lifted the battery out of the compartment and the (+) lead twisted. I...

I am building a EX2 and the battery box is rough 3.5" x 5" x 6.15" it looks like the https://www.jegs.com/i/Braille-Batte.../B129/10002/-1 is too...

If you’re still interested in the paint equipment, please contact me. John Cooley

The Denso voltage regulator is integral to the alternator. Since you have changed the alternator and the problem didn't change it's unlikely that...

a loose wire or something is fooling the alternator into thinking voltage is low... EarthX says this is not battery related, but I still wonder

These are voltage and amperage data from prior to voltage issue, and since voltage issue (sorry they are sideways). The noise in alternator output...

It still sounds like an instrumentation error. I think you need to measure the voltage at the 12 V Aux outlet when the high indicated voltage...

Thanks Pete! Can I get one made of fiberglass instead of CF?

Yes, Lewaero Works makes fuel or cargo options that fit the Carbon Cub. No STC required on experimental aircraft. Email parts@cubcrafters.com...