I have been studying the G3X touch installation manual and pilot guide, on and off, for several months. However, I have not yet found a method of saving the entire G3X system configuration to the SD card. I may wish to change some configuration settings but I'd be reluctant to do that unless I can restore the original, as delivered, CubCrafters' settings and/or any configuration I may have created after delivery.
I assume that CubCrafters will load a standard configuration during production and perhaps tweak some calibrations or settings for individual aircraft. Are those baseline and aircraft specific configuration files available to the aircraft owner?
Can the aircraft owner save the current G3X configuration file(s) to the SD card? if so, where is that documented?
I'm hopeful that all this is possible since Vans Aircraft describes some of what I'm asking about here -
https://www.vansaircraft.com/wp-cont...E-11-29-18.pdf
Thanks,
Andy