Good morning all,
ran into another roadblock yesterday... decided to sleep on it but this morning still no answers.
on my left wing with the inboard aileron false spar inboard end flush with the inboard side of flap/aileron hangar and the outboard aileron false spar outboard end flush with the outboard machined rib I end up with an annoying little gap of about 1/8 inch where the two false spars are supposed to nest together at rib 9.
i have the 51 1/8 inch measurement almost dead on, my machined ribs are square with the spar.
anybody have any ideas?
Dewey