Chuck, I just sprayed it on a qtip first and used that to apply it to the small area where it came through the fabric and then used some “blending solvent” mixed in about 25% to first area and then went 50% and blended out further.....to blend it in after filling the fixed area with several full strength coats of paint. Then a little mild compounding outside the last blend coat area.

3F6D8EC7-065D-4E32-BF6E-228B1FA7D1F1.jpg

Quote Originally Posted by ceslaw View Post
Well, Dave, you just made my day.

I had the exact same issue with a leak from the fuel selector causing a bit of discoloration in the paint, and it would not hold the touch up paint. Never occurred to me to use the Bull Dog on it. I will do so, and fix that small but annoying issue. Good tip.

I believe I posted on that leaky valve issue, long ago. Turned out the O rings were fractionally too small, compared to the replacements. I always suspected there would be a rash of builders with leaky valves.

Chuck