Results 1 to 4 of 4

Thread: Couple Q's about Tools on EX2 Build

  1. #1
    Junior Member
    Join Date
    Apr 2018
    Location
    Spokane, Wa
    Posts
    3

    Default Couple Q's about Tools on EX2 Build

    The Cleveland Tool kit recommends 20-150 IN.-lb TQ Wrench. I've got a 40-200 in.-lbs, will I need the 20-40 in.-lbs capability?

    The kit also recommends 2" Yoke and 2.5" Flange/Longeron Nose for squeeze rivet tool. I've got a Tatco rivet squeezer with 3" Yoke and 2" Longeron Yoke, will this work? I also seen where someone recommended the "main squeeze" Cleveland offers, is there that much squeeze riveting on the kit to justify?

  2. #2
    Senior Member c130jake's Avatar
    Join Date
    Jun 2012
    Location
    Minneapolis, MN
    Posts
    190

    Default Re: Couple Q's about Tools on EX2 Build

    I got a 5-40 inlb torque screw driver, worked well with floor board screws.

    Sent from my SM-G930V using Tapatalk
    Jake
    Finished CCEX N96FV!

  3. #3
    Junior Member
    Join Date
    Apr 2018
    Location
    Spokane, Wa
    Posts
    3

    Default Re: Couple Q's about Tools on EX2 Build

    Perfect thanks Jake!

  4. #4
    Junior Member
    Join Date
    Apr 2018
    Location
    Spokane, Wa
    Posts
    3

    Default Re: Couple Q's about Tools on EX2 Build

    Got the 5-40 in-lb screwdriver and went ahead and ordered the main squeeze with Clevelands Yoke's. Should be cooking with gas when the kit shows up. Super pumped!!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •