I'm installing my Gen 3 Acme Aero on my EX2. Had to turn down the spacers nearest the centerline of the fuselage by 0.014 each to fit in the Cabane Vee. Nice to have a metal lathe. They fit perfectly now. The shocks were shipped with shims, which I did not need to use. Interesting, the bolt through holes in the spacers are off center, so I set both sides so the hole was set closest to the midline of the aircraft. I wonder if this is the best setup? Does it matter as long as both sides are installed in a similar manner?

David

IMG_7245.jpg

IMG_7246.jpg