Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Over-Voltage

  1. #11
    Junior Member
    Join Date
    Feb 2010
    Location
    Yakima, WA
    Posts
    13

    Default Re: Over-Voltage

    Quote Originally Posted by gderamel View Post
    Also, would someone explain why the two voltages? Is the left side (#1) the Primary battery, and the right side the Emergency Backup Battery? When I do the preflight Ignition check, with the key on Right "mag" (electronic Ignition) and the Emerg. Backup Battery switch "ON" the #1 or #2 voltage drops to 12.0v (ish) and the other voltage stays at 14.4 (ish). I'm assuming the 14v is showing the charging Primary BATT and the 12v is the current state of the Backup BATT?
    This is a great question, hopefully the following will answer it.

    When the backup battery is engaged it isolates the backup system such that only the backup battery is connected to the right-hand (R) ignition and only the R ignition is connected to the backup battery. This is done for two reasons.

    The first reason is so that the pilot can check the operation of the complete ignition backup battery system at the pre-takeoff check. During normal operation the R ignition is running from the main battery that is tied in with the rest of the electronics. The backup battery is getting charged through a diode so that a main system low voltage condition cannot discharge the backup battery. This diode is the reason why there is a slight voltage difference between the main battery and the backup battery during normal operation. When the backup switch is turned on, the two electrical systems are separated, and the backup battery is no longer getting 14.4v from the alternator and it drops it's internal voltage. If the systems weren't separated, the pilot could not be sure that the backup battery is in good state because the alternator or main battery would still be providing the power that could mask any shortcomings in the backup battery. The same reasoning that this check must be done with the key in R, so that the L ignition system doesn't mask any problems by running the engine during the check of the R ignition system and the associated backup battery.

    The second reason is that isolation, once that backup switch is engaged, none of the rest of the electrical system can interfere with that backup battery powering that R ignition.

    That said, you are seeing normal operation when the main battery is still charging via the alternator and is at 14.4v (ish) and the backup battery drops to 12.0v (ish) because it is disconnected from the rest of the electrical system including the alternator.

    I hope this answers your question and helps others in understanding the ignition backup battery system.

    I also agree that is great info on comparing the batteries, thanks for sharing.

  2. #12
    Member DRL's Avatar
    Join Date
    Nov 2011
    Location
    Camarillo, CA
    Posts
    66

    Default Re: Over-Voltage

    We have managed to run the EarthX below it's 11V cutoff a few times. We just used a quality automatic charger to recharge it. We also disconnect the charger when the charge amps read zero, before it goes into the maintain mode. It takes only about 45 minutes. Nevertheless, we keep an eye on the process and do not leave it unattended with the charger on.

    There is a procedure to hook up another battery to get it out of a deep discharge, but we have not had to do that.

    The factory data suggests the discharge curve is very steep after 11v, but overall useful time to cutoff seems to be as long or longer than the others, before it will no longer support the ignition and it is necessary to switch to the standby system.

    We live in warm weather, so we don't know how it will do in the cold. The only con so far is the reputation of Lithium and that may be enough for some to look else ware, but in the last 18 months, we have had no problems.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •