Results 1 to 2 of 2

Thread: Crank sensor install

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Senior Member TroyBranch's Avatar
    Join Date
    May 2015
    Location
    Calgary Alberta Canada
    Posts
    313

    Default Crank sensor install

    Here is a couple shots of what my wiring looks like. I taped a piece of 032 to the sensor then installed the ring gear. Pushed them up tight and tightened each screw so it would not move. Removed the ring gear, tighten one screw more to be sure it did not move. Take out one screw and add some blue loctite. Re install to finally torque then do the same on the other screw. Repeat for other sensor. You will need a long Allen key to get to the bottom screws when the ring gear is on.



    Also on the coils really do your best to support lines coming off the coil. This will help eliminate any chance of a connector failure. I added heat shrink to both wires, just to help stiffen them up.



    Sent from my iPhone using Tapatalk
    Last edited by TroyBranch; 05-07-2016 at 05:16 PM.

  2. #2
    Senior Member c130jake's Avatar
    Join Date
    Jun 2012
    Location
    Minneapolis, MN
    Posts
    190

    Default Re: Crank sensor install

    Thanks, I was thinking about the spacing last night.

    Sent from my SM-G920V using Tapatalk
    Jake
    Finished CCEX N96FV!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •