Another question. On the volts display I have two pointers, 1 and 2. I'm gussing one is the the battery, what is two reading?
Another question. On the volts display I have two pointers, 1 and 2. I'm gussing one is the the battery, what is two reading?
I was hoping it is reading volts of the ignition back up battery. But it reads the same volts as my main battery as my back up is not in yet. Being able to monitor the volts of the back up ignition is important to me. Looking forward to hearing the answer.
Sent from my iPhone using Tapatalk
Volts 1 is Main Bus voltage and Volts 2 is ignition Backup Battery Voltage. Troy, not sure what yours is reading? I will check mine as well.
This is is from the CC manual:
Volts two goes to the back up battery switch. It looks like it will read main battery volts when the switch is off and back battery when the switch is on and back up is in use. At least that is what it looks like to me.
Sent from my iPhone using Tapatalk
Correct. When the backup switch is off, the voltage readout come from the charging bus. When the switch is on, it shows the voltage from the backup battery.
switch.jpg
N80DB #119 E-LSA / G3X Touch
It it is in the G3X AFM supplement
N80DB #119 E-LSA / G3X Touch
At the risk of placing my ignorance on full display for all to see: Where do I fine the "G3X AFM supplement"?
I found it towards the end of this file
http://www.cubcrafters.com/technical...cations/3/view
N80DB #119 E-LSA / G3X Touch