Results 1 to 3 of 3

Thread: Lighting Wiring and Installation

  1. #1
    Member jmorrical's Avatar
    Join Date
    Aug 2014
    Location
    The Woodlands, TX
    Posts
    90

    Default Lighting Wiring and Installation

    I am ready to cover the fuselage. Can't decide what I'm to do with this orange tail light harness ring wire connector. I know the Molex and spade connectors are to connect to the installed rudder wiring for the tail light. It looks like it's a solder shield splice for the ground of the shield. Where do I connect it?

    KWTn7D5HTSqp38VIkuw+Rg.jpg
    Jim Morrical

  2. #2
    Senior Member
    Join Date
    Jul 2015
    Location
    Broken Arrow, OK
    Posts
    535

    Default Re: Lighting Wiring and Installation

    Jim,

    Donít worry about it for now. Later the ring connector end will be a ground connected to the little bolt/nut that holds the Data plate onto the fuse mounting plate there under the right stabilizer.

    Quote Originally Posted by jmorrical View Post
    I am ready to cover the fuselage. Can't decide what I'm to do with this orange tail light harness ring wire connector. I know the Molex and spade connectors are to connect to the installed rudder wiring for the tail light. It looks like it's a solder shield splice for the ground of the shield. Where do I connect it?

    KWTn7D5HTSqp38VIkuw+Rg.jpg
    Dave Embry
    "You only live once.....
    ..but if you do it right.....
    ....once is enough."..

  3. #3
    Senior Member Pete D's Avatar
    Join Date
    Jan 2010
    Location
    Yakima, WA
    Posts
    936

    Default Re: Lighting Wiring and Installation

    Now would be a good time to clean the powder coat off by the screw hole it goes on the back side of the data tag tab so you don't have to do it inside the tail withe the fabric on.
    Pete Dougherty
    R & D Shop Manager
    Cub Crafters Inc

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •