I am confused with the manual on trix nuts install.

Manual says....Then place the skylight into position and make sure that this edge distance will result in a proper edge distance in the Plexiglas.

The turtle deck is carbon fiber and the wings are not on yet. I measured and drilled the 3/16 holes in the middle of the flange. Does this step assume the wings are on? I hate to finish drilling to #3 for the trix nut if it's not going to fit. Does the plexi go that far back?

Any trick to trix nuts? I bought the tool but have never seen one. ( first time builder-non mechanic)

Thanks

Jake


Sent from my iPad using Tapatalk