Page 2 of 2 FirstFirst 12
Results 11 to 14 of 14

Thread: Carbon Fiber Door Headers

  1. #11
    Senior Member Cubrath's Avatar
    Join Date
    Jun 2013
    Location
    Spearfish, SD
    Posts
    302

    Default Re: Carbon Fiber Door Headers

    I think it would hold up great. They use it on car hoods and it holds up very well on them. I am planning on using it on mine.

    MR

  2. #12
    Junior Member chrism's Avatar
    Join Date
    Dec 2011
    Location
    Grand Rapids, MI
    Posts
    25

    Default Re: Carbon Fiber Door Headers

    photo-66.jpg Here is what we did, we bought a sheet of carbon fiber in the same patter and cut it out for the headers and panel. Turned out nice.

  3. #13
    Senior Member Cubrath's Avatar
    Join Date
    Jun 2013
    Location
    Spearfish, SD
    Posts
    302

    Default Re: Carbon Fiber Door Headers

    Looks good! I would take the instrument panel outside and look at it in the sun and make sure you want wrap on that. First, the carbon fiber pattern is a little hard to look at for hours at a time. Also, you might find the glare on the gloss might be a little much. Just make sure you like it before you go through all the work to put it on the panel.

    MR

  4. #14
    Junior Member
    Join Date
    Oct 2012
    Location
    swanton vt
    Posts
    25

    Default Re: Carbon Fiber Door Headers

    I did instrument and overhead panels in carbon fiber vinyl from yipes stripes. Has a flat finish. Holding up well a year later.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •