Results 1 to 2 of 2

Thread: CC Spar lay out

  1. #1
    Junior Member
    Join Date
    Apr 2014
    Location
    Brisbane Australia
    Posts
    21

    Default CC Spar lay out

    Morning all from Down Under.... My kits hopefully on the way and have just been prepping my shop..I have a question re saw horses and spar positioning..The horses are 151" apart and level..my question is is there a measurement from the tip to the centre line of the saw horse or from the inboard end of wing to the saw horse centre line... Because I was wondering if this would effect the 1" block screwed to the outboard horse and placement span wise along and under the rear spar...Appreciate your feed back
    Kenny Edwards
    Brisbane
    Australia

  2. #2
    Senior Member ceslaw's Avatar
    Join Date
    Sep 2013
    Location
    Carterville, IL
    Posts
    589

    Default Re: CC Spar lay out

    Distance from tip of wing to saw horse won't make a wit of difference. The distance between the saw horses and the one inch block will determine washout.

    You will find yourself moving the wings a bit one way to the other to facilitate assembly.

    The wash out won't really even be an issue until you trammel the drag wires and again when you add the leading skins, wing tips, and tighten the fuel tanks. That is when it will start to tighten up

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •