Activity Stream

As I'm sure you probably will, I'd still check with CC on why (if correct) the 25hr interval? If you are like me, it seems I'd changing oil quite...

This appears to be Lycoming current recommendation: https://www.lycoming.com/content/oil-and-filter-change-recommendations My PA28 O-360 ran...

Thanks for the report. So now the mystery is re-opened and I thought I completely understood it.

I stick to around 30hrs

I tried your procedure this afternoon but was unable to reproduce your results on my FX3 today. The stall horn will not sound with master,IBBS and...

I would interpret that as a 25hr oil change. It's probably standard cut and paste for cleaning the breather tube. Also at the bottom of the page...

I had not looked at the magnetometer installation recently and had forgotten that the GMU 22 does not have a CAN Bus interface (the later GMU 11 is...

I change my oil around 30hrs or as soon as it starts looking dirty. I’ve gonna 50 on trips and didn’t like it. Emailing Pete at factory best way to...

I just watched the G3X installation video Mitch did on an EX3. Near the end he talked about installing the Artex 345 ELT. The two wire switch was...

Would someone please tell me the recommended oil change interval for the CC363i.

Don't forget that the GDU 465 must be configured to give the required data format on RS-232 port 5. I don't know what the default is but I assume...

I don't see a magnetometer in the schematic you showed. I don't know how many ADAHRS/magnetometer configurations CubCrafters has used. On the...

Yes, you need to be aware of the flap actuator movement. That does limit where you can cut a hole for the switch.

I am building an EX1. I have noticed the Executive Glass Manual shows the CAN bus network with a Can Bus Terminator Block at the GUS 25 ADAHRS. I...

Andy, Thanks, that totally cleared the intercom C/B fog. I will removed the C/B and cap the hole.

So an EAA friend with lots of wiring experience helped me understand the GPS source wiring for my Artex 345. I've seen the Garmin Manual info but it...

Dave - you rock! Thank you :)

It would be interesting to see a power budget both for a functioning alternator and for alternator failure. I suspect they (high power lights) would...

Great response by Bruce, I don't think there was ever any question that the AeroLED is a brighter choice. The only factor left out was the new...

Disclaimer: I am not here to bash another brand of light, just to make sure everyone has the facts to make an apples to apples comparison of the...

And here’s a shot from today too of the T3. When I had the Pawnee spring and this dedicated 3200 with the tail ski I would usually get shimmy...

Yes you’re sharp eyed there Andy. Acme G3’s with safety cables. I might have a better picture I can put in showing them.

I knew I could count on you for some cool ones.

I think I see Acme with safety cables. I was told told safety cables not required with Acme but I have since found they are recommended by Acme...

Can I add a cool picture from today? I’m sure there are guys that will recognize where this is. Hint, it is in Idaho.