Activity Stream

Good food, good life. The cleanliness is spot on too. Love it! Yang | garbage disposal

I see that Engine Monitor GEA 24 connector J244s pins 41, 42, 43 and 44 are respectively assigned as Discrete In 1,2,3 and 4. As Andy said they are...

I think the exhaust flow is pretty much confined to the under side. I have a Vetterman exhaust system, not the original CC style that has the...

I don't know the flow of air but a thought is if there could be a vent in the aft of the fuselage that would cause any air within to flow out the aft...

While this does not answer your question specifically as I run Dynon I would suggest just to keep it simple. For a 1 1/2 years I have run the...

I would have thought these tail openings would be insignificant compared to the huge holes provided for trim movement of horizontal stab. Isn't...

Nice picture👍

I was able to make another flight today with the tape as shown earlier. I flew into the Idaho backcountry on skis and it was about an hour flight to...

You would need no additional wiring to customize the voltmeter and ammeter red and amber bands for this battery. If you want to wire the battery...

I have had my CO condition for a couple of years. I get 5 to 15 ppm in cruise and 75 to 125 ppm while landing and for a brief time on the ground. I...

It has been a long time for me since I have dealt with these issues. I am Board Certified in Aerospace Medicine and even had a tour of two years as a...

Thanks, that's a factor I had not considered. I'm familiar with my hypoxia symptoms as I have 2 "chamber rides" and lots of time in gliders at high...

The combination of altitude exposure and CO exposure has to be viewed very differently than the typical ppm limits at sea level. CO displaces oxygen...

I wonder if you are setting the bar a bit too high - https://tinyurl.com/ak5s4b6v https://tinyurl.com/3cwbv53n Interesting discussion...

Incremental improvements with my setup. With the tape as shown in post 77 below, I made a 20 minute flight and saw single digits in cruise and a...

It doesn't look very reliable ! :D

Is the guy with the stock 65hp J3 that won the second year going to be there? Glenn

Taped around the teardrop and a couple of holes I drilled for wires to the LEDs I installed on the gear. No joy.

This is the way my was configured originally. Bungees, then AOSS and now Acme.

There’s a few running around

Hi Andy, Yes, Klaus was very insistent that the sensors don't fail and given that he is the expert I don't know what to make of the evidence I...

What does the manufacturer of the magnetometer recommend? Typically a metal tubular fuselage is not a good place for mounting. I have not heard of...

The only place I can think of where a lubricated thread is recommended on a Cub type airplane are the engine cylinder base studs. I installed my...

I had hydrosorb/bungees on my EX to begin with. I did not fair them. I used the black vinyl snap on pouches that Dodge sells. Easier to inspect the...