Activity Stream

Kit Support is sending a CAN Bus terminator for the GSU jumper's 9 pin connector (P251).

For me that would seem like a distraction from looking outside. When I’m in places that are gnarly I need to be looking all around. And better yet,...

Florida in January. Nice. This was Montana earlier this month. But a sunrise not set.

I don’t have a light but that’s just about where I put mine. That’s low enough so it is out of the way of the flap actuator. hopefully you never...

Really nice sunsets last couple days

When they close the runway and you have 250’ in the back yard. Acmes do extremely well in rough stuff. https://vimeo.com/503673875

I've been hoping someone would give their experience about placing the two wire switch for the Artex 345, but since nobody has I’m moving on. I have...

Still waiting to see if there is room for the switch just aft of the light on right header. If you know, please respond.

How to install would be the next question. I ordered it to have with me at build week which I'm headed to Yakima soon. I'll see if the avionics...

From the G3X Touch Installation Manual - "2.1.1.21 Carbon Monoxide Detector A CO Guardian or other compatible carbon monoxide detector can be...

I wasn't aware of that. Very cool. Thanks for the suggestion.

If you're going to spend that much why not consider one that will interface with the G3X system? ...

This was in my aircraft spruce email today. Any opinions? I like that it's something always monitoring and can alert vs. me having to take readings...

Thanks Mark

What I say here may not be correct, but what I've come to understanding. I have spent a good bit of time trying to interpret the Cubcrafters...

Sold!

Can you give me a call ,Darrell

The brake and wheel set is still available, sold the tires.

Yep :)

Interested in your wheel, brake set, are they still available?

Good morning, do you still have the 29” bushwheels and wheel brake set.

Hi Wayne You can reach Pete and I at Kitsupport@cubcrafters.com. Pete and I spoke and we believe this is the 2nd time we have seen this. Please...

The bolt grip on the strut blocks on front and rear spar do not go all the way through with the bolts supplied in the kit. The wing manual said you...

Depends on the size of the wires and the size of the connector pin. It will make no difference whether the splice is at the pin or a few inches away...

Here's what I did. I cut notches in the floor board to fit around the braces as small as I could and still get the floorboard in. In the extended...

The question still remains from a previous post - how to wire the shield and ground at the ARTEX connector. From the drawing it looks like you have...