Activity Stream

Everybody had a good time. Such fun. nad+ supplement

Just saw your post. The Beringer ALG system is about as close as you can get to having a bounce free landing in a CC. So handling cross wind landings...

John, The clamps arrived today! Many thanks! Pete

Hi John, I'll take the Genius G3500 charger, if still available. Steve (859) 336-3680

Thank you...Got to get some for the new machine.

3/4" tubes on an XCub with either engine.

46 hours flown in 9 days to complete the fly-off and bring it home so not in any big rush to go out to the hangar. I did spend a few minutes seeing...

Sure. What is your address?

jim. That’s a gap but you should be able to take 1” wide chafe tape and run it the full length of that seem. Do it to all of the over laps. When...

Can I please get one too?

Thanks Dan. I'll continue my research, certainly want to do no harm with whichever process I use. We are in a salty environment, I feel I do need to...

Thank you. 👍

I understand your concern, possibly some food for thought. All of the sheet metal will be Alclad or clad aluminum (the best corrosion protection)....

Your clip went in the mail today!

I received your email, and your clip will go out in tomorrow's mail.

just emailed you. let me know if you received it. thanks Bruce!

I put chafing tape there before I covered. No filler.

Make sure the thickness is not larger that the strut attachment. If it slides on fine with the fabric plus paint, no issue with fabric there.

Starting to cover the wings. I have seen various fillers used in places like the extended cargo door. The transition from the first and second...

I have not received an email or pm, yet. You can try sending it to bamgraham66@me.com.

Thank you Troy

I would really like one of these. Have tried to come up with a good option but never seems to last. Sent you an email and pm Bruce. Thanks

I was able to see the CHT-1 probe and trace the wiring after removing the right side lower cowling louver. The connection between the probe leads...

no need to cut it back at all. Paint it up and then use a dreamer and wire wheel to clean off where strut forks slide on. It’s necessary to ream...